|RL1030 Waveform Generator Software
|RL1009 USB to GPIB Software
Extend the read and write timeouts from 5.1s to 1.3k s. Update the Python examples.
|RL1000 Efficiency Meter Software
Fixed RL1009 GPIB compatibility bugs.
Update the RL1009 GPIB compatibility.
Added the capability to use the RL1009 USB to GPIB controller board to communicate with GPIB controlled instruments.
Changed the meter discovery routine so the RL1000 can be used simultaneously with LTC Quickeval.
Fixed log sweep bug, copy data and graph when undocked, and erratic behavior with the ratio entry.
Added current tracking and current summing features when using multiple meters.
Fixed the known Access Violation bugs.
Improved the Windows VISTA installation. Make sure to run the install program as an administrator.
Added scripting support for the DC590B USB to Serial Board. Enables bi-directional I2C and SPI serial communications.
Add scripting capability.
Add the ability to enter the number of the graph to be deleted.
Include a stand alone calibration program. Only use if you know what you are doing.
Redo the current tracking function so no math is necessary.
Add the PWM voltage to the servo sources.
Add the ability to delete traces from the graph.
Add current load tracking with multiple meters.
Change the step functionality to allow the user to enter values.
Make the label lines thicker.
Add the ability to save the spreadsheet data in .csv format.
Change the maximum number of displayable sweeps from 5 to 10.
Add the ability to undock the sweep control as well as the graph.
Add legend line capability to the graph labels.
Eliminate a bug with the filename extensions when saving the graph as a bitmap or JPEG.
Eliminate the bug that reset the sweep number when moving back and forth between the Sweep and Spreadsheet tabs when a sweep was being performed.
Eliminate a bug with the step variable during a sweep not controlling the PWM and voltage outputs correctly.
Add the ability to undock the graph so it can be resized.
Add equation capability to the data and graph.
Fix a bug in the dx & dy algorithm.
Add the ability to change the graph size.
X & Y information is displayed when the mouse is over a graph data point.
Graph data points can be selected, and a linear fit run to calculate slope.
Add USB Low Voltage warning.
Servo Loop will turn off when the measured value drops to 1/10 of its value. Most useful when the output of an external power supply being servoed is disabled.
Add support for a GPIB controlled electronic load.
New servo loop can control analog power supply.
Reglator and current load power limiting protection added.
Current meter compensation for the voltmeter input impedance.
Allow the sweep variable to decrease in value as well as increase.
Add the ability to sweep the regulator voltage and the external power supply.
Put a lower limit on the delta_x step size when implementing the Maximum Delta Y algorithm so it won't hang when the slope is high.
Save the yaxis,yaxis2 and xaxis combobox index in the ini file.
Change the timer inverval to seconds and the stop value to minutes.